How Much Do Dock Leveler Replacement Parts Cost? 2026 Pricing Guide
One of the most common questions we get is simply: "how much is this going to cost me?" before a facility manager commits to a repair. Unlike a full leveler replacement (which can run five figures installed), most dock repairs are a single worn part. Here's real, current pricing across the categories we sell most.
Small hardware: $6 – $15
Fasteners and small hardware are the cheapest fix and the most commonly under-ordered — facilities often replace one washer or nut instead of the full set, and the leveler fails again within months. A 1-1/4" Flat Washer and Serrated Flange Nut both run around $6 each; a Hook Key is about $11. Buy these in sets, not singles, if the unit has more than one worn fastener.
Mechanical wear components: $70 – $190
Rollers, bearings, springs guides, and plungers fall in this range. A Carriage Roller runs about $70, a Blue Giant Bearing & Flange and Spring Guide are roughly $143 each, and a TKO Plunger is about $186. These are the parts most likely to fail from normal duty cycles — expect to replace them every few years on a high-traffic dock.
Electrical components: ~$960+
Control and terminal boards are the most expensive single-part repair short of a full leveler replacement, but still a fraction of the cost of replacing the unit. A Terminal Board runs around $964. If your leveler has no power at all, confirm the board is actually the fault (check breakers and connections first) before ordering — it's a non-returnable electrical part.
Dock door protection: $1,700+
Track protectors sit at the higher end because they prevent much larger, recurring damage. An AP9661 Impact-A-Track runs about $1,711 installed but typically pays for itself by eliminating repeat track and door repairs from forklift strikes.
Budgeting a repair
Most single-part dock leveler repairs land between $6 and $200. Anything above that — terminal boards, track protection, or multiple simultaneous part failures — is worth a quick call to confirm you're ordering the exact part for your brand and model before you spend the money. We're glad to help you get it right the first time.
Sample Image Gallery
